Skip to content

Monroe PMP -

Sections
Handles
:
Hand Wheels
:
Clamps
:
Knobs
:
Work Holding
:
Plungers
:
Custom Metal Stamping
:
Magnets
:
Pins
:
Hinges
Personal tools
Sections
Home - Monroe
Products
Order
Register
Information Request
Request For Quote
Become a 3Sixty Company
Add to Favorites
Contact Us:
68 S. Squirrel Rd
Auburn Hills, MI 48326
Ph:800.440.3967
Fx:800.453.9683

Outside USA:
Ph: 248.844.2601
Fx: 248.844.2617

Hours of Operation:
8am - 7pm EST
Monroe Cage Code
3SixtyGroup Companies
You are here: Home → Hinges → Monroe: Hinges
Document Actions

Monroe: Hinges

by Tony Losey — last modified 2005-11-21 08:43

Sleeves (Tapped Hole and Through Hole)

How To Order Hinges

When Ordering Please Specify
  • Series Number
  • Hinge Length
  • Open Width (unequal leaves, specify leaf widths)
  • Material Thickness and Type
  • Pin Diameter
  • Type of Swaging
  • Finish Required
  • Quantity
  • Hinges with Holes, Forming, etc., Need Blueprint or Sample Provided
 All Hinges Available with…
  • Swaging
  • Offsetting forming
  • Holes in any pattern
  • Notching
  • Trimming
  • Unequal leaves cut to your specified length
  • Assembled or unassembled
  • Other pin sizes than listed
  • Other knuckle sizes than listed
  • Brass, stainless steel or aluminum pins
  • Plating to your specifications, such as zinc, nickel and chrome, etc.
  • Spring loaded
  • Pins plain, cold formed or spun ends
  • Any type of construction
  • Steel, stainless steel and aluminum in stock; brass and galvanized on special order.
 
  1. Hinge Length - the length of the leaves measured parallel to the pin.
  2. Hinge Width - the overall dimension of the leaves measured across the knuckle.
  3. Leaf Width - the dimension from the center of the pin to the outer edge of the leaf.
  4. Knuckle Length - the nominal or typical dimension of the knuckle measured parallel to the pin.
  1. End Play - the amount of axial movement between the leaves.
  2. Pitch - the dimension from a point on the knuckle to the same point on an adjacent knuckle on the same leaf.
  3. Paint Clearance - the minimum dimension between the outer face of the knuckle and the opposing edge of the leaf cut out over the entire range of pivotal movement of the hinge.

HINGE ASSEMBLY, LEAF FORMING, SWAGING AND OFFSETTING AVAILABLE

Plain or Standard Assembly
Leaves lay flat in the same plane in an open position.
Reverse Assembly
Opposing leaves extend laterally from opposite sides of the pin in the open position. Leaves will not close to parallel position.
Unequal Leaves
One Leaf Formed 90°
Two Leaves Formed 90°
Multiple Barrel
Multiple Leaves
One Leaf Half Swaged
One leaf swaged one half of pin diameter
Both Leaves Half Swaged
One half of pin diameter.
One Leaf Full Swaged
The diameter of pin.
One Leaf Reverse Swaged
The diameter of knuckle or reverse swaged leaves will not close to a parallel position.
Offset
Forming of one or both leaves to provide more clearance between the leaves in closed position.

© Copyright Monroe Engineering Products, Inc 2003 All rights reserved.